If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Enable macro
I have just switched to Windows XP/Word 2003 on a new PC.
I had a "send to xxx.dot" on Word 2000 which I had put in the Word start up folder and had as an addition in Templates/Add-ins. It enabled me to press File/Send to... and copy the file to another folder. I have copied this macro over to my new PC and it shows up where I expected. Unfortunately, when I try to run it, I get the 'helpful' macro security help file or "Copy failed, command failed". Also, I cannot run the macros under Tools | Macro | Macros ... although I can see them in the macro box. I just get "The macros in this project are disabled." I have tried so many help files that I'm getting dizzy! I would really appreciate any help. TIA hkbs |
#2
|
|||
|
|||
Enable macro
Replied to duplicate question, in this group.
Cindy Meister |
#3
|
|||
|
|||
Enable macro
Sorry Cindy - very new to this latest set up!
"Cindy M -WordMVP-" wrote in message news:VA.0000b271.00ac8335@speedy... Replied to duplicate question, in this group. Cindy Meister |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Save document without saving macro within it? | Dave Peterson | General Discussion | 0 | November 16th, 2004 11:42 PM |
Keyboard Shortcut Only Runs Part of the Macro | Jonnyboy117 | General Discussion | 2 | July 14th, 2004 08:27 PM |
Need Entry Point 18 Help On Access Executable File | Jeff Conrad | General Discussion | 26 | July 14th, 2004 06:00 AM |
Macro when a font in a range changes | whisperinghill | General Discussion | 0 | June 14th, 2004 07:21 PM |
Cannot delete macro LookupMW | Min | New Users | 7 | June 10th, 2004 03:27 AM |