|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 14th, 2007, 02:46 PM
posted to microsoft.public.access.reports
|
|||
|
|||
I need to go from one point to other in the same report using a ?
I have two tables and i need to put a menu that make a jump to one table or
to other like hyperlink. but in a same report. 
|
|
#2
August 14th, 2007, 05:06 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
I need to go from one point to other in the same report using a ?
As far as I know, you cannot do this in Access reports.
-- John Spencer Access MVP 2002-2005, 2007 Center for Health Program Development and Management University of Maryland Baltimore County .. "Luis P." wrote in message ... I have two tables and i need to put a menu that make a jump to one table or to other like hyperlink. but in a same report.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
