|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 23rd, 2009, 07:47 PM
posted to microsoft.public.visio.general
|
|||
|
|||
else blocks in UML sequence diagrams
I can't figure out how to do an else block (an if..then..else) kind of flow
in MS Visio sequence diagrams. Please help. 
|
|
#2
November 23rd, 2009, 09:31 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
else blocks in UML sequence diagrams
On Mon, 23 Nov 2009 11:47:02 -0800, Newmanb1 wrote:
I can't figure out how to do an else block (an if..then..else) kind of flow in MS Visio sequence diagrams. Operators in UML sequence diagrams were introduced in UML2, Visio implements UML 1.3 I think. -- Regards, Paul Herber, Sandrila Ltd. SDL/MSC/TTCN/URN/UML2 for Visio http://www.sdl.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
