If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VBA to autofill from relative location
If I need to autofill column B from the last cell that has data in it to the
same row as the last cell of column A that has data in it, how do I set the destination for the autofill correctly? I have tried a lot of ways that seemed obvious and all of them return errors. Here is where I am stuck: Selection.AutoFill Destination:=Range(B[this number is the active cell, or the one I just put a value in in column B]:B[this number should be the same as the last cell that has a value in it in column A]) |
#2
|
|||
|
|||
VBA to autofill from relative location
Try
Dim lngRow As Long lngRow = Cells(Rows.Count, "A").End(xlUp).Row Selection.AutoFill Destination:=Range("B" & ActiveCell.Row & ":B" & lngRow) -- Jacob (MVP - Excel) "AlexJarvis" wrote: If I need to autofill column B from the last cell that has data in it to the same row as the last cell of column A that has data in it, how do I set the destination for the autofill correctly? I have tried a lot of ways that seemed obvious and all of them return errors. Here is where I am stuck: Selection.AutoFill Destination:=Range(B[this number is the active cell, or the one I just put a value in in column B]:B[this number should be the same as the last cell that has a value in it in column A]) |
#3
|
|||
|
|||
VBA to autofill from relative location
Good deal, thank you!
I was forgetting to put a "&" in there... -A "Jacob Skaria" wrote: Try Dim lngRow As Long lngRow = Cells(Rows.Count, "A").End(xlUp).Row Selection.AutoFill Destination:=Range("B" & ActiveCell.Row & ":B" & lngRow) -- Jacob (MVP - Excel) "AlexJarvis" wrote: If I need to autofill column B from the last cell that has data in it to the same row as the last cell of column A that has data in it, how do I set the destination for the autofill correctly? I have tried a lot of ways that seemed obvious and all of them return errors. Here is where I am stuck: Selection.AutoFill Destination:=Range(B[this number is the active cell, or the one I just put a value in in column B]:B[this number should be the same as the last cell that has a value in it in column A]) |
Thread Tools | |
Display Modes | |
|
|