|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 12th, 2009, 02:49 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
Column sizing
On my chart, I have data for 12 months and then a rollup for the year.
Because the rollup column is so large, the chart is automatically adjusting for the largest column. Is there a way I can put a "break" in the year column so that the individual months will display relative to each other rather than relative to the year column? 
|
|
#2
March 12th, 2009, 03:07 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
|
Column sizing
I'm using Excel 2007
"CJ" wrote: On my chart, I have data for 12 months and then a rollup for the year. Because the rollup column is so large, the chart is automatically adjusting for the largest column. Is there a way I can put a "break" in the year column so that the individual months will display relative to each other rather than relative to the year column?
|
|
#3
March 12th, 2009, 04:40 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
|
Column sizing
This describes the protocol in Excel 2000-2003:
http://peltiertech.com/Excel/Charts/BrokenYAxis.html Excel 2007 would use the same steps, although the commands are scattered in wildly different places. - Jon ------- Jon Peltier, Microsoft Excel MVP Peltier Technical Services, Inc. http://PeltierTech.com/WordPress/ _______ "CJ" wrote in message ... I'm using Excel 2007 "CJ" wrote: On my chart, I have data for 12 months and then a rollup for the year. Because the rollup column is so large, the chart is automatically adjusting for the largest column. Is there a way I can put a "break" in the year column so that the individual months will display relative to each other rather than relative to the year column?
|
|
#4
March 12th, 2009, 04:56 PM
posted to microsoft.public.excel.charting
|
|||
|
|||
|
Column sizing
Thank you. I'll give it a go.
"Jon Peltier" wrote: This describes the protocol in Excel 2000-2003: http://peltiertech.com/Excel/Charts/BrokenYAxis.html Excel 2007 would use the same steps, although the commands are scattered in wildly different places. - Jon ------- Jon Peltier, Microsoft Excel MVP Peltier Technical Services, Inc. http://PeltierTech.com/WordPress/ _______ "CJ" wrote in message ... I'm using Excel 2007 "CJ" wrote: On my chart, I have data for 12 months and then a rollup for the year. Because the rollup column is so large, the chart is automatically adjusting for the largest column. Is there a way I can put a "break" in the year column so that the individual months will display relative to each other rather than relative to the year column?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
