|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 3rd, 2004, 02:51 PM
|
|||
|
|||
Getting error when trying to open a table or form
When I try to open either a table or form, I get this error message:
"Selected collating sequence not supported by the operating system." Does somebody know what is wrong? I use Access97 and Windows98/ NT4 
|
|
#2
May 3rd, 2004, 02:56 PM
|
|||
|
|||
|
Getting error when trying to open a table or form
Here is a link with information on this error:
http://support.microsoft.com/default...b;en-us;184988 -- Cheryl Fischer, MVP Microsoft Access Law/Sys Associates, Houston, TX "Jan GT" wrote in message om... When I try to open either a table or form, I get this error message: "Selected collating sequence not supported by the operating system." Does somebody know what is wrong? I use Access97 and Windows98/ NT4
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
