If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Controlling connectors on cross-overs (intersections)
When two connector lines intersect, one of them will have a break or won't
have a break depending on the behavior settings for those lines. How does one make one line jump over the other line with a half circle (standard pipeline nomenclature for cross-overs)? Also, is it possible to have regular lines behave this was too, or only connector type lines? Thanks, Mike |
Thread Tools | |
Display Modes | |
|
|