If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Room Measurement Tool or Controller dimension?
I would like to know how to change the variables in either of these two
tools. i.e. a 4x4 square = 1 ft. How can I make it = to 10 ft? |
#2
|
|||
|
|||
Room Measurement Tool or Controller dimension?
On Mon, 17 May 2010 09:39:01 -0700, Ray wrote:
I would like to know how to change the variables in either of these two tools. i.e. a 4x4 square = 1 ft. How can I make it = to 10 ft? Look at the page scaling menu File - Page setup - Drawing Scale -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|