If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Changing the grid size in design view
I am using Access 2007 and I have a form I created from a table. I cannot get
the form grid to change the width. It's stuck on a little short of 8 inches wide and I would like it to be only 5 inches wide. I am using it in Popup mode and it has a lot of white space to the right side that is empty. OF course the user can change the form each time in form view but if I could change the size of the grid in design view they wouldn't have to monkey with when they open the form. Thanks for looking at my problem. |
#2
|
|||
|
|||
Changing the grid size in design view
if you can not narrow a form while in design mode - then something is keeping
it wide... there has been more than once where I've found myself with the same situation and it is always very narrow lines put in the form wizard.....sometimes widening all the sections is the best way to see the trouble maker line but alot of times it is right by the section break...sometimes they are so grey I could really not see them due to the lack of contrast.... -- NTC "Skip Bisconer" wrote: I am using Access 2007 and I have a form I created from a table. I cannot get the form grid to change the width. It's stuck on a little short of 8 inches wide and I would like it to be only 5 inches wide. I am using it in Popup mode and it has a lot of white space to the right side that is empty. OF course the user can change the form each time in form view but if I could change the size of the grid in design view they wouldn't have to monkey with when they open the form. Thanks for looking at my problem. |
#3
|
|||
|
|||
Changing the grid size in design view
On Fri, 4 Jan 2008 16:27:00 -0800, NetworkTrade
wrote: there has been more than once where I've found myself with the same situation and it is always very narrow lines put in the form wizard.....sometimes widening all the sections is the best way to see the trouble maker line but alot of times it is right by the section break...sometimes they are so grey I could really not see them due to the lack of contrast.... One way to find these annoying controls is to - in design mode - click on some control (doesn't matter which); then leave the mouse strictly alone, and use the Tab key to jump from control to control. At some point you should see two small black boxes, the "handles", of the line control; at that point you can either resize the line or just press the Delete key to remove it. John W. Vinson [MVP] |
#4
|
|||
|
|||
Changing the grid size in design view
Thanks for your help. It happened to be a text box in the header area that
extended out. "John W. Vinson" wrote: On Fri, 4 Jan 2008 16:27:00 -0800, NetworkTrade wrote: there has been more than once where I've found myself with the same situation and it is always very narrow lines put in the form wizard.....sometimes widening all the sections is the best way to see the trouble maker line but alot of times it is right by the section break...sometimes they are so grey I could really not see them due to the lack of contrast.... One way to find these annoying controls is to - in design mode - click on some control (doesn't matter which); then leave the mouse strictly alone, and use the Tab key to jump from control to control. At some point you should see two small black boxes, the "handles", of the line control; at that point you can either resize the line or just press the Delete key to remove it. John W. Vinson [MVP] |
Thread Tools | |
Display Modes | |
|
|