If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can you add second text blocks on a connector line 1 on each end?
Is it possible to add second text blocks on a connector line, one at each end
of the connector? |
#2
|
|||
|
|||
Can you add second text blocks on a connector line 1 on each end?
Not that I know of. You'll either have add the text boxes manually or add
them to your shapes or place to dynamic connectors on top of each other. Adding them to the shape seems to be the least painful, at least it's only done once and always there with copy and paste of the shape. HTH Wapperdude "db4jazz" wrote: Is it possible to add second text blocks on a connector line, one at each end of the connector? |
#3
|
|||
|
|||
Can you add second text blocks on a connector line 1 on each end?
You can copy a dynamic connector, convert it to a group and then add
your own text box to the group, with its position handled by an additional control point. If you re-route the connector, the text handling isn't quite as good as the actual connector text block that visio controls, but I have found it near enough. db4jazz wrote: Is it possible to add second text blocks on a connector line, one at each end of the connector? |
#4
|
|||
|
|||
Can you add second text blocks on a connector line 1 on each e
I wish thank you for your great answer, though I am not querist.
The Menu "Shape/Grouping/Convert to Group" is the magic menu I was looking for many days. As I am not aware of the function of this menu, I've wasted much time to convert shapes to group. Everything will get better from now on. Thank you again. -- JuneTheSecond Now, visual calculation is more visual. http://www.geocities.jp/visualcalcul...ish/index.html |
Thread Tools | |
Display Modes | |
|
|