|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 9th, 2004, 01:49 PM
|
|||
|
|||
Visio 2k and WordPerfect 10
Copy/paste a Visio 2k drawing into WordPerfect 10 works OK, but a message
pops up "No server for this object is installed on this computer"; double-click does not open it in Visio. Is this a WordPerfect or Visio installation issue? Pemo -- ,-._|\ / Oz \ Melbourne \_,--.x/ Australia v 
|
|
#2
August 11th, 2004, 02:16 PM
|
|||
|
|||
|
Visio 2k and WordPerfect 10
Worked it out. Visio 2k had lost its association with *.vsd files.
Evil Emperor Zurgates must have heard me muttering nastiness about MS :-) Pemo -- ,-._|\ / Oz \ Melbourne \_,--.x/ Australia v "Pemo" wrote in message ... Copy/paste a Visio 2k drawing into WordPerfect 10 works OK, but a message pops up "No server for this object is installed on this computer"; double-click does not open it in Visio. Is this a WordPerfect or Visio installation issue? Pemo -- ,-._|\ / Oz \ Melbourne \_,--.x/ Australia v
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wordperfect Password Conversion | economic56 | General Discussion | 0 | June 29th, 2004 04:28 PM |
| Věc: Sorting a Table created in WordPerfect and Converted to Word | poster | Tables | 0 | April 28th, 2004 11:26 PM |
Linear Mode
