If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access Report Printout
Can anyone help?
I am sure there is a basic answer to this but... How do I change the page break on a report?. I would like to include all the details pertaining to one record on one page only. I have checked the amount of space available and it should fit, but the details stop half way and get pushed on to a second page. Any advice would be appreciated. Thank you |
#2
|
|||
|
|||
Access Report Printout
There is nothing inherent in Access that causes "break when approximately
halfway through the data in a detail section". It is something about the specifics of your report, data, etc., which, of course we do not have. If you can clarify, with some detail, then someone may be able to help you find the problem. Remote debugging is difficult at best, but without information, it's impossible. Larry Linson Microsoft Access MVP "Ethel" wrote in message ... Can anyone help? I am sure there is a basic answer to this but... How do I change the page break on a report?. I would like to include all the details pertaining to one record on one page only. I have checked the amount of space available and it should fit, but the details stop half way and get pushed on to a second page. Any advice would be appreciated. Thank you |
Thread Tools | |
Display Modes | |
|
|