If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Linking (Drill Down) of shapes
I'm building a multi-layer diagram, using basic black box
layering. I want to be able to link a process to an exploded diagram on a spearate page, detailing the next level of granularity (double clicking on the shape brings up the exploded page). This was easy to do in ABC Flowcharter, but I haven't been able to do this in Visio. Is there a way to do this in Visio 2000? Thanks in advance kevin |
#2
|
|||
|
|||
Check out the "off-page reference" shape on the Basic Flowchart stencil.
"Kevin" wrote in message ... I'm building a multi-layer diagram, using basic black box layering. I want to be able to link a process to an exploded diagram on a spearate page, detailing the next level of granularity (double clicking on the shape brings up the exploded page). This was easy to do in ABC Flowcharter, but I haven't been able to do this in Visio. Is there a way to do this in Visio 2000? Thanks in advance kevin |
#3
|
|||
|
|||
Another way is to change set the [Go to page] parameter of
the [Double-Click] event. This can be accessed from the Behavior item on the Format menu or the shortcut menu of the selected shape. KT |
#4
|
|||
|
|||
Another way is to change set the [Go to page] parameter of
the [Double-Click] event. This can be accessed from the Behavior item on the Format menu or the shortcut menu of the selected shape. KT |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
programming: Referencing Shapes inside a Group | nyar | Visio | 1 | July 16th, 2004 03:19 AM |
Keeping Records in Linking Table Accurate (Long Post) | Ben Johnson | Running & Setting Up Queries | 0 | June 14th, 2004 08:13 AM |
Shape references to shapes on different pages | Mark K | Visio | 1 | May 15th, 2004 04:00 AM |
Electrical (Logic) Shapes in visio | Geert Vancompernolle | Visio | 2 | April 26th, 2004 09:21 AM |