If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Default snap and glue settings
I'm tired of having to change my snap and glue settings from the default
settings every time I create a new diagram. How can I change it so the default setting for "Snap", in particular, is de-selected? |
#2
|
|||
|
|||
Default snap and glue settings
All you really need to do is adjust the settings to the desired position then
save the Visio drawing as a template. This should hold all your settings so the next time you open the template the snap and glue will have retain your values. -- James Wittrell Microsoft Support "kathyincanada" wrote: I'm tired of having to change my snap and glue settings from the default settings every time I create a new diagram. How can I change it so the default setting for "Snap", in particular, is de-selected? |
Thread Tools | |
Display Modes | |
|
|