If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Page size not available
I use Visio to mark up PDFs from an architect, which are each the size of
their specific project. I do not print them locally but must re-generate a PDF in the same size as the original. That size is not listed in the Printer Paper pull down (Architectural E2 for example). Therefore I cannot return a marked up project in the size needed. How do I make a paper size without a printer attached locally? |
#2
|
|||
|
|||
Page size not available
On Wed, 19 May 2010 20:26:01 -0700, HWL wrote:
I use Visio to mark up PDFs from an architect, which are each the size of their specific project. I do not print them locally but must re-generate a PDF in the same size as the original. That size is not listed in the Printer Paper pull down (Architectural E2 for example). Therefore I cannot return a marked up project in the size needed. How do I make a paper size without a printer attached locally? http://www.windowsitpro.com/article/...-printer-.aspx -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|