If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Profile Wizard not functioning as intended
Using the Custom Installation Wizard, I created a simple
profile to put 'Toolbars on two rows' and change one button on the toolbar for Office 2003 Professional. The profile works for Excel and PowerPoint but will not under any circumstances work for Word. On many occasions we have re-installed the image to the network. Several times we have re-created the MST and OPS files from scratch only to end up with the same outcome. We used the same technique to create an Office 2003 Standard install w/ profile and it rolls out with absolutely no problems at all. Any ideas or suggestions would be greatly appreciated. Thanks, Ken |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Profile Wizard Switches - Office 2K3 | Ken | Setup, Installing & Configuration | 1 | September 7th, 2004 12:04 AM |
Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
OAB in automatic profile generation | Christophe Rome | Installation & Setup | 1 | June 17th, 2004 02:38 PM |