If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to take a 8x10 project and change it to two 5x7s?
I created a project that I need to break into two 5x7's. How do I do this?
|
#2
|
|||
|
|||
How to take a 8x10 project and change it to two 5x7s?
Ideally you should have set up your publication in the size you needed it
but since it's too late for that............ You are going to have issues because the proportions are not the same. I would convert it to a .pdf and then print it scaled down to the size you need (or something close to that size). -- JoAnn Paules MVP Microsoft [Publisher] Tech Editor for "Microsoft Publisher 2007 For Dummies" "cynthia101" wrote in message ... I created a project that I need to break into two 5x7's. How do I do this? |
Thread Tools | |
Display Modes | |
|
|