If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Orientation of text in an autoshape
In Excel 2003, I have a rectangle that is tall and thin. I want to put
some text inside it, but I need the text oriented 90 degrees in the rectangle. Is this possible? If so, how? Thanks, Tonso |
#2
|
|||
|
|||
Orientation of text in an autoshape
I will assume a recatngle fro the Drawing Toolbar.
Right-click on the edge of the rectangle and "Format Autoshape" and on Alignment tab choose your orientation. Gord Dibben MS Excel MVP On Wed, 21 Apr 2010 12:32:58 -0700 (PDT), Tonso wrote: In Excel 2003, I have a rectangle that is tall and thin. I want to put some text inside it, but I need the text oriented 90 degrees in the rectangle. Is this possible? If so, how? Thanks, Tonso |
#3
|
|||
|
|||
Orientation of text in an autoshape
On Apr 21, 7:45*pm, Gord Dibben gorddibbATshawDOTca wrote:
I will assume a recatngle fro the Drawing Toolbar. Right-click on the edge of the rectangle and "Format Autoshape" and on Alignment tab choose your orientation. Gord Dibben *MS Excel MVP On Wed, 21 Apr 2010 12:32:58 -0700 (PDT), Tonso wrote: In Excel 2003, I have a rectangle that is tall and thin. I want to put some text inside it, but I need the text oriented 90 degrees in the rectangle. Is this possible? If so, how? Thanks, Tonso- Hide quoted text - - Show quoted text - Gord, Thank you so very much again for your expert help! That did the trick! I truly appreciate all the help i get on this site, from the MVPs and others. Thanks so much again. Tonso |
Thread Tools | |
Display Modes | |
|
|