If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
VB capability missing in Access 2007
I increased my RAM and added a new graphics card on my computer running
Windows XP. After a few days I was asked to reactivate windows because of the significant change in hardware. I was prepared to do it, but it proved impossible. In the end after several session with a microsoft windows technical guy, I had to backup all my data and carryout a clean install, without my new graphics card. The clean install also meant all my software, was deleted, and had to be reinstalled. The problem is now, having reinstalled Office 2007 professional, all the VB code, I had written into my databases, isn't working. I decided to rebuild one of them from scratch. I built the tables and then created a form, using one of the tables as the data source. I added a button to the form, and wrote 2 lines of code in the click event. However, when I tested the button, the code didn't run. I tried debugging the code by stepping into each line, but it still didn't run. Where as the VB gone? |
#2
|
|||
|
|||
VB capability missing in Access 2007
Have you defined the folder in which the database resides as a Trusted
Location? -- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no private e-mails, please) "ArkRoyal" wrote in message ... I increased my RAM and added a new graphics card on my computer running Windows XP. After a few days I was asked to reactivate windows because of the significant change in hardware. I was prepared to do it, but it proved impossible. In the end after several session with a microsoft windows technical guy, I had to backup all my data and carryout a clean install, without my new graphics card. The clean install also meant all my software, was deleted, and had to be reinstalled. The problem is now, having reinstalled Office 2007 professional, all the VB code, I had written into my databases, isn't working. I decided to rebuild one of them from scratch. I built the tables and then created a form, using one of the tables as the data source. I added a button to the form, and wrote 2 lines of code in the click event. However, when I tested the button, the code didn't run. I tried debugging the code by stepping into each line, but it still didn't run. Where as the VB gone? |
Thread Tools | |
Display Modes | |
|
|