If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Auto-generated Report
I have a form with a command button. If the EndUser clicks the button a
report [rptUTILITIES] is generated and saved to the hard drive and the EndUser moves to the next form without even knowing the report was generated and saved. How would I code this? Let me thank you ahead of time. Thank you. |
#2
|
|||
|
|||
Auto-generated Report
Hello Tim,
Look in the Click event of the button. There's a line of code to save the report and then a line of code that looks like: DoCmd.OpenForm "NameOfNextForm". Add the following code between these two lines of code: MsgBox "The Utilities Report has been saved to the harddrive" Steve "Timothy Millar" wrote in message news I have a form with a command button. If the EndUser clicks the button a report [rptUTILITIES] is generated and saved to the hard drive and the EndUser moves to the next form without even knowing the report was generated and saved. How would I code this? Let me thank you ahead of time. Thank you. |
Thread Tools | |
Display Modes | |
|
|