|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 4th, 2009, 11:08 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Visio 2007 - Ethernet shape - adding connections
The standard Ethernet shape only has 5 connectors for connecting to devices.
How can I add one or more additional connectors? 
|
|
#2
June 5th, 2009, 12:38 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Visio 2007 - Ethernet shape - adding connections
"InterOp" wrote in message
... The standard Ethernet shape only has 5 connectors for connecting to devices. How can I add one or more additional connectors? There are two extra control points located on the center line of the shape. Drag them outside the shape to make the lines visible. Under those are more control points. There should be about sixty four control points that you can connect to. John... Visio MVP
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
