If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
units
Hi, I'm needing to adjust the height of the cell but the measurement is in
pixels, can I change it to inches? Mindy |
#2
|
|||
|
|||
http://209.196.177.41/01/01-09.htm
-- Regards, Peo Sjoblom "Mindy" wrote in message ... Hi, I'm needing to adjust the height of the cell but the measurement is in pixels, can I change it to inches? Mindy |
#3
|
|||
|
|||
Note that row heights are measured in points, there are 72 points to the
inch pixels are video card dependent (resolution etc) -- Regards, Peo Sjoblom "Peo Sjoblom" wrote in message ... http://209.196.177.41/01/01-09.htm -- Regards, Peo Sjoblom "Mindy" wrote in message ... Hi, I'm needing to adjust the height of the cell but the measurement is in pixels, can I change it to inches? Mindy |
#4
|
|||
|
|||
I'm sorry I'm still having trouble, the dimensions are 1 by 2 5/8 inches. I
suck with math so could you help me convert that to pixels please? "Peo Sjoblom" wrote: Note that row heights are measured in points, there are 72 points to the inch pixels are video card dependent (resolution etc) -- Regards, Peo Sjoblom "Peo Sjoblom" wrote in message ... http://209.196.177.41/01/01-09.htm -- Regards, Peo Sjoblom "Mindy" wrote in message ... Hi, I'm needing to adjust the height of the cell but the measurement is in pixels, can I change it to inches? Mindy |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing Secondary axis value units | sherobot | Charts and Charting | 4 | May 2nd, 2005 07:00 PM |
Product Labels - "1 of 3 Units" ????? | Brian via AccessMonster.com | Setting Up & Running Reports | 3 | April 13th, 2005 02:11 PM |
Page margin units | Alberto | Worksheet Functions | 2 | April 2nd, 2005 12:23 AM |
ruler units are in characters and lines, not inches | Ward | Page Layout | 1 | August 1st, 2004 01:01 AM |