If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I expand the envelope selection in Access page setup?
I am developing an application in Access 2000 that requires the selection of
several different sizes of envelopes. The page setup has been installed on a tool bar but only a few of the envelope sizes are shown. Also, If I select the custom size, the popup for entering the sizes does not appear. How can I add the additional sizes and how do I get the popup to appear? Any help would be greatly appreciate! I'm stuck!! Thanks in advance! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Print page footer only when needed | Carl Rapson | Setting Up & Running Reports | 9 | November 14th, 2005 07:57 PM |
How do I set a Default in page setup on an Access Report / Snapsh | ILuvAccess | General Discussion | 0 | September 8th, 2005 04:23 PM |
Why is a French Spellchecker a "required" update for English speak | French Spellcheck Required? | General Discussion | 23 | April 26th, 2005 01:17 AM |
How can I save Page Setup settings in Microsoft Access 2003? | Elaine | General Discussion | 2 | November 3rd, 2004 10:03 PM |
Page Setup: Horizontal and Vertical Page Alignment | Frustrated | Page Layout | 1 | April 26th, 2004 06:22 PM |