If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3D effect by making an arrow piercing trough a plane
Hello,
I am a newbie to VISIO (using 2003). So I cannot really tell whether what I want to do is simple or simply too much to ask. I have a flat shape, a square in my case, and I want to have an arrow going trough it, by that resembling a 3D effect. This means that the part of the arrow that is "behind" the shape should be invisible and the part of the arrow starting where it "breaks/pierces" through the shape, i.e. the part that is in "front" of the plane, should be visible. I was experimenting with sending shapes to back or front. But this only works for the whole shape and not parts of it. Any ideas? Thanks and best, Stefan |
#2
|
|||
|
|||
3D effect by making an arrow piercing trough a plane
Hi Stefan,
I couldn't resist. Have a look he Faking 3D in Visio http://www.visguy.com/2009/12/10/faking-3d-in-visio/ -- Hope this helps, Chris Roth Visio MVP For in-depth Visio articles, Visio tutorials and free Visio shapes, stencils and templates, check out my web site: Visio Guy http://www.visguy.com For more Visio discussion, visit our forum (complete with pictures and downloads!): Visio Guy Forum http://www.visguy.com/vgforum "stefan" wrote in message ... Hello, I am a newbie to VISIO (using 2003). So I cannot really tell whether what I want to do is simple or simply too much to ask. I have a flat shape, a square in my case, and I want to have an arrow going trough it, by that resembling a 3D effect. This means that the part of the arrow that is "behind" the shape should be invisible and the part of the arrow starting where it "breaks/pierces" through the shape, i.e. the part that is in "front" of the plane, should be visible. I was experimenting with sending shapes to back or front. But this only works for the whole shape and not parts of it. Any ideas? Thanks and best, Stefan |
Thread Tools | |
Display Modes | |
|
|