If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how do i change from read only on files i created?
I created several files on a CD, and the system saved them as Read Only. I
need to change them to RAM. Help!! |
#2
|
|||
|
|||
how do i change from read only on files i created?
Copy the file to the hard drive, if necessary right click on the filename in
Windows Explorer and click on Properties then remove checkmark from Read Only then OK, open in the program to change files, save back to hard drive and then burn back to another CD unless that CD is an RW then save the file back to the same CD. Any file saved to a CD-R is automatically saved as a read only file and will not be able to be edited and saved back to the same CD-R. It is unadvisable to attempt direct reads and saves from and to a RW disk, or any other removable device, even if you can get it to work. "skpt5n" wrote in message news I created several files on a CD, and the system saved them as Read Only. I need to change them to RAM. Help!! |
Thread Tools | |
Display Modes | |
|
|