If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I print upside down back of Christmas card
have an A4 sheet - printed photo on bottom half
How do I type a publisher not on the top half which will be the back of the card when folded i.e. I have to rotate text 180 decrees. |
#2
|
|||
|
|||
On Sat, 4 Dec 2004 09:31:03 -0800, "Anthony Berend" Anthony
wrote: have an A4 sheet - printed photo on bottom half How do I type a publisher not on the top half which will be the back of the card when folded i.e. I have to rotate text 180 decrees. See http://www.word.mvps.org/FAQs/DrwGrp...deDownText.htm -- Regards, Jay Freedman Microsoft Word MVP FAQ: http://word.mvps.org |
#3
|
|||
|
|||
Change the paper orientation to landscape. Then use text boxes with the text
rotated 90 degrees. Also rotate any pictures, clip art, etc by 90 degrees. You can fold the paper, then write big numbers on each page, unfold it and use it as a guide for where to put your text and pictures. "Anthony Berend" Anthony wrote in message ... have an A4 sheet - printed photo on bottom half How do I type a publisher not on the top half which will be the back of the card when folded i.e. I have to rotate text 180 decrees. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
christmas card list | sgcasey | General Discussion | 1 | December 11th, 2004 05:43 AM |
How do I print the details view | David | Running & Setting Up Queries | 5 | August 28th, 2004 12:17 AM |
recall card print | JIM.H. | Setting Up & Running Reports | 1 | August 9th, 2004 09:13 PM |
Can't print from MS Office Programs | AL | General Discussions | 0 | August 4th, 2004 11:33 PM |
Database design for ID Card | Randy Hartwick | Database Design | 2 | May 6th, 2004 09:34 PM |