If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
can't select a macro
I run daily reports and email to our team. Then a second macro is done on
those reports. If I run the second report before I close out of the report, no problem. But if I open up the email and try to run the 2nd macro it will not show my macro's and I cannot use the short cut key. I have to re save the report and then I can see my macro's. This problem has just started. Any ideas what I have done? Donna |
Thread Tools | |
Display Modes | |
|
|