If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I stop my cursor defaulting as an eraser in powerpoint?
I have recently installed Microsoft Office 2007 and on powerpoint the cursor
is defaulting as an eraser. Consequently as I create slides they do not show up until either I run the cursor over them or I press enter to finish the slide. It must be a setting but I can not locate where to turn it off. |
Thread Tools | |
Display Modes | |
|
|