If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CAD file not getting inserted in Visio 2007
When I try to insert AutoCAD 2007 dwg file in visio 2007, I am getting the
following error: Cannot open file. The file may not be a DWG or DXF file, it may not be in a supported version of the DXF file format, or it may be corrupted. Check the file and try again. Kindly advise on how to insert Autocad file and also convert it into visio shapes. |
#2
|
|||
|
|||
CAD file not getting inserted in Visio 2007
On Mon, 20 Oct 2008 00:29:51 +0530, "S N" wrote:
When I try to insert AutoCAD 2007 dwg file in visio 2007, I am getting the following error: Cannot open file. The file may not be a DWG or DXF file, it may not be in a supported version of the DXF file format, or it may be corrupted. Check the file and try again. Kindly advise on how to insert Autocad file and also convert it into visio shapes. I doubt Visio 2007 can import from as recent as AutoCAD 2007. Can you save the AutoCAD file in an earlier format? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|