|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 16th, 2004, 02:38 AM
|
|||
|
|||
Show Tools menu after turning off in Startup options?
Is there any way to get the default menus back after unchecking the "show
menus" checkbox in the Startup options? tia 
|
|
#2
November 16th, 2004, 12:12 PM
|
|||
|
|||
|
try holding down the shift key while you open the database.
-----Original Message----- Is there any way to get the default menus back after unchecking the "show menus" checkbox in the Startup options? tia .
|
|
#3
November 16th, 2004, 12:18 PM
|
|||
|
|||
|
If you open the database while holding down the Shift key, all startup
options, amcros code etc. are ignored, so you'll get the full menu back and you'll be able to change the settings. HTH, Nikos "HB" wrote in message ... Is there any way to get the default menus back after unchecking the "show menus" checkbox in the Startup options? tia
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unable to access "OPTIONS" from Tools Menu | didge | Worksheet Functions | 1 | June 3rd, 2004 07:20 PM |
| Menu Options "grayed out" but still functional through macros | Worksheet Functions | 1 | October 30th, 2003 05:10 PM | |
| Security tab missing in Tools -> Options | Varun | Worksheet Functions | 1 | October 16th, 2003 12:31 AM |
Linear Mode
