If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Using report wizard w/heirarchy
When you use the report wizard, it seems to only allow you to have one field
in each group in a hierarchy, which leads to a lot of manual formatting. Is there a way to tell it you want Organization Department FirstName LastName Phone etc. ContactDate etc. Thanks; Amy |
#2
|
|||
|
|||
Using report wizard w/heirarchy
As far as I know there is no way to do that using the wizard. Manual
formatting is required. "Amy Blankenship" wrote in message ... When you use the report wizard, it seems to only allow you to have one field in each group in a hierarchy, which leads to a lot of manual formatting. Is there a way to tell it you want Organization Department FirstName LastName Phone etc. ContactDate etc. Thanks; Amy |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Has anyone seen this behaviour? What might it be? | tw | General Discussion | 4 | June 30th, 2005 03:23 PM |
To Sharkbyte and all: Calculate a total values in group level | Ally | General Discussion | 6 | June 13th, 2005 08:16 PM |
Using Report Wizard to build report from Query | spartanmba | Setting Up & Running Reports | 4 | April 3rd, 2005 12:14 AM |
Display Parameter from Form on Report | sara | Setting Up & Running Reports | 10 | July 19th, 2004 04:54 PM |
Save Report With CreateReport Coding Issue | Jeff Conrad | Setting Up & Running Reports | 8 | July 12th, 2004 08:39 AM |