If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to print a document partially landscape and partially portrai
I have a word document that starts out portrait and then switches to
landscape about half way through. It looks fine when I scroll through the document but when I try to print - it comes out all portrait - and it just shrinks the text in the landscape section to fit the portrait. Any suggestions would be greatly appreciated. |
#2
|
|||
|
|||
How to print a document partially landscape and partially portrai
Usually this is a limitation of the printer driver. Many duplex printers
will not mix portrait and landscape on the same sheet of paper. Even worse are that some printers refuse to have portrait and landscape in the same print run (those these are unusual). Are you able to test the document with a different printer? -- Terry Farrell - MSWord MVP "btupper2001" wrote in message ... I have a word document that starts out portrait and then switches to landscape about half way through. It looks fine when I scroll through the document but when I try to print - it comes out all portrait - and it just shrinks the text in the landscape section to fit the portrait. Any suggestions would be greatly appreciated. |
#3
|
|||
|
|||
How to print a document partially landscape and partially port
Thanks Terry - I will try it on a different printer in my office or maybe
stop trying to have it do things like double side and staple. Maybe by just making it simple for the printer will allow it to happen. Bret "Terry Farrell" wrote: Usually this is a limitation of the printer driver. Many duplex printers will not mix portrait and landscape on the same sheet of paper. Even worse are that some printers refuse to have portrait and landscape in the same print run (those these are unusual). Are you able to test the document with a different printer? -- Terry Farrell - MSWord MVP "btupper2001" wrote in message ... I have a word document that starts out portrait and then switches to landscape about half way through. It looks fine when I scroll through the document but when I try to print - it comes out all portrait - and it just shrinks the text in the landscape section to fit the portrait. Any suggestions would be greatly appreciated. |
#4
|
|||
|
|||
How to print a document partially landscape and partially port
I have they same problem, I have access various printers and they all do the
same. It would work fine if you first converted to PDF and print it from acrobat. I would really like a solution for this. My client doesnt want to go thru the conversion for every file they have to print in duplex mode. "btupper2001" wrote: Thanks Terry - I will try it on a different printer in my office or maybe stop trying to have it do things like double side and staple. Maybe by just making it simple for the printer will allow it to happen. Bret "Terry Farrell" wrote: Usually this is a limitation of the printer driver. Many duplex printers will not mix portrait and landscape on the same sheet of paper. Even worse are that some printers refuse to have portrait and landscape in the same print run (those these are unusual). Are you able to test the document with a different printer? -- Terry Farrell - MSWord MVP "btupper2001" wrote in message ... I have a word document that starts out portrait and then switches to landscape about half way through. It looks fine when I scroll through the document but when I try to print - it comes out all portrait - and it just shrinks the text in the landscape section to fit the portrait. Any suggestions would be greatly appreciated. |
Thread Tools | |
Display Modes | |
|
|