|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 28th, 2004, 04:22 AM
|
|||
|
|||
using a decimal point changes cell to label
When I type a decimal (110.25) it changes it to a label
(100. 00). I have reloaded the operating system and the program. Any ideas. 
|
|
#2
February 28th, 2004, 05:11 AM
|
|||
|
|||
|
using a decimal point changes cell to label
Perhaps your Control Panel Regional Settings are incorrectly set (using a
comma rather than a period as the decimal separator). -- Vasant "Adam" wrote in message ... When I type a decimal (110.25) it changes it to a label (100. 00). I have reloaded the operating system and the program. Any ideas.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
