If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Opening Page Change MS Pub 2002 ?
When I open Microsoft Publisher 2002, the opening
page shows Icons of aall the Publication Designs which need to be switched off before commencing a new project. How may I arrange that the opening page is "ready to start new project" i.e. blank? Thank you. |
#2
|
|||
|
|||
Opening Page Change MS Pub 2002 ?
Tools, options, clear "Use catalog at startup."
-- Mary Sauer MSFT MVP http://office.microsoft.com/ http://msauer.mvps.org/ news://msnews.microsoft.com "John" wrote in message ... When I open Microsoft Publisher 2002, the opening page shows Icons of aall the Publication Designs which need to be switched off before commencing a new project. How may I arrange that the opening page is "ready to start new project" i.e. blank? Thank you. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Office 2003 Standard MultiLingual User Interface (MUI) installation | [email protected] | Setup, Installing & Configuration | 3 | May 23rd, 2006 11:59 AM |
Page Numbers | Aurora | General Discussion | 0 | November 17th, 2005 08:04 PM |
No page #s appear on 1st 2 pgs after section split in Pub2K3 | GPSIS | Publisher | 9 | November 15th, 2005 08:35 PM |
Auto numbering | store5064 | General Discussions | 11 | June 2nd, 2005 08:38 PM |
FIrst page footers | Noel S Pamfree | General Discussion | 7 | December 6th, 2004 08:49 PM |