If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Transferring shapes/models.
This is probably an FAQ but I could not see an answer readily.
I have a drawing that I generated through reverse engineering a project. Now that I have created alot of drawings I am finding that there are additional shapes and objects that I need. If I reverse engineer the whole solution then I get the objects and shapes but that file does not have the drawings that I have created. I need to either transfer the drawings to the "solution reverse engineered" file or transferr the objects and shapes to the file that I have the drawings under. I am not sure how to do either. Thank you. Kevin |
Thread Tools | |
Display Modes | |
|
|