If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Table Header Row doesn't repeat
I have a table with row 1 defined as a repeating header row. Table
Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#2
|
|||
|
|||
Table Header Row doesn't repeat
The following has previously been posted when that problem has come up:
Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#3
|
|||
|
|||
Table Header Row doesn't repeat
I revealed hidden formatting codes and looked through three times for section
or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#4
|
|||
|
|||
Sue, try unchecking "Heading rows repeat", reselect yr table header, and check "Heading rows repeat" again. I don't know why but sometimes it mriaculously solves the problem.
HTH - Henk Quote:
|
#5
|
|||
|
|||
Table Header Row doesn't repeat
Thanks, but I've tried that. I've removed the heading rows. I've tried
making more rows the repeated rows. Nothing changed. I'm sure it's something simple, but it beats me what it is. They worked when I originally created the table. I didn't notice when they disappeared to know what I may have done to make it happen. "Henk57" wrote: Sue, try unchecking "Heading rows repeat", reselect yr table header, and check "Heading rows repeat" again. I don't know why but sometimes it mriaculously solves the problem. HTH - Henk Sue D;2366086 Wrote: I revealed hidden formatting codes and looked through three times for section or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: - The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ...- I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. - - -- Henk57 |
#6
|
|||
|
|||
To repeat the table header if using a section break
Go to where you want to apply the break Then, go to Home Paragraph Page Break Before Quote:
|
#7
|
|||
|
|||
Table Header Row doesn't repeat
On the Table tab of the Table Properties dialog, make sure that Text
wrapping is set to None in the bottom half of the dialog. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I revealed hidden formatting codes and looked through three times for section or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#8
|
|||
|
|||
Table Header Row doesn't repeat
That was the problem!! I selected None and my headings appeared. Thank you.
"Doug Robbins - Word MVP" wrote: On the Table tab of the Table Properties dialog, make sure that Text wrapping is set to None in the bottom half of the dialog. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I revealed hidden formatting codes and looked through three times for section or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#9
|
|||
|
|||
Table Header Row doesn't repeat
I have tried all these things and still doesn't work. Using Word 2002.
"Sue D" wrote: That was the problem!! I selected None and my headings appeared. Thank you. "Doug Robbins - Word MVP" wrote: On the Table tab of the Table Properties dialog, make sure that Text wrapping is set to None in the bottom half of the dialog. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I revealed hidden formatting codes and looked through three times for section or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. |
#10
|
|||
|
|||
Repeat table headers
Just to say how useful this posting was and this site is - just started using Mac Office and hit this very problem with the same solution and outcome
Sue wrote: That was the problem!! 14-Sep-07 That was the problem!! I selected None and my headings appeared. Thank you. "Doug Robbins - Word MVP" wrote: Previous Posts In This Thread: On Saturday, September 08, 2007 2:12 AM Sue wrote: Table Header Row doesn't repeat I have a table with row 1 defined as a repeating header row. Table Properties confirms the setting. However, the row does not repeat on any page. I cannot find a manual page break in the table. I have run a repair of the software. This table is 16 pages long so a header row is desired. On Thursday, September 13, 2007 5:44 AM Doug Robbins - Word MVP wrote: Table Header Row doesn't repeat The following has previously been posted when that problem has come up: Make sure the table is not wrapped and has no breaks and that you don't have all the rows set as heading rows. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... On Thursday, September 13, 2007 10:50 AM Sue wrote: I revealed hidden formatting codes and looked through three times for section I revealed hidden formatting codes and looked through three times for section or page breaks and did not see any. Table Properties shows only row 1 as the header row. I'm not sure what you mean by not wrapped. If you mean the table is wider than the paper, I changed Table Properties to set the table width at 100% and still have the problem. "Doug Robbins - Word MVP" wrote: On Thursday, September 13, 2007 4:17 PM Henk57 wrote: Sue, try unchecking "Heading rows repeat", reselect yr table header, andcheck Sue, try unchecking "Heading rows repeat", reselect yr table header, and check "Heading rows repeat" again. I don't know why but sometimes it mriaculously solves the problem. HTH - Henk Sue D;2366086 Wrote: -- Henk57 On Thursday, September 13, 2007 5:46 PM Sue wrote: Thanks, but I've tried that. I've removed the heading rows. Thanks, but I've tried that. I've removed the heading rows. I've tried making more rows the repeated rows. Nothing changed. I'm sure it's something simple, but it beats me what it is. They worked when I originally created the table. I didn't notice when they disappeared to know what I may have done to make it happen. "Henk57" wrote: On Friday, September 14, 2007 1:57 AM Doug Robbins - Word MVP wrote: On the Table tab of the Table Properties dialog, make sure that Text wrapping On the Table tab of the Table Properties dialog, make sure that Text wrapping is set to None in the bottom half of the dialog. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "Sue D" wrote in message ... On Friday, September 14, 2007 8:26 PM Sue wrote: That was the problem!! That was the problem!! I selected None and my headings appeared. Thank you. "Doug Robbins - Word MVP" wrote: On Wednesday, February 04, 2009 1:02 PM easbrow wrote: I have tried all these things and still doesn't work. Using Word 2002. I have tried all these things and still does not work. Using Word 2002. "Sue D" wrote: On Wednesday, February 04, 2009 2:54 PM Doug Robbins - Word MVP wrote: Send me the document and I will take a look at it for you.-- Hope this helps. Send me the document and I will take a look at it for you. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "easbrown" wrote in message ... Submitted via EggHeadCafe - Software Developer Portal of Choice Putting Twitter Realtime Search to Work http://www.eggheadcafe.com/tutorials...-realtime.aspx |
Thread Tools | |
Display Modes | |
|
|