If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Page Setup Problem
I am running an MDE file on the Access 2002 runtime. I try to change the Paper Size on a report to A4, but it does not save the setting. I know this was an issue with Access 2000 addressed with KB 208912 and KB 240826. However, I am not changing the printer port as in 208912, and I don't have Name AutoCorrect enabled as in 240826. Has anybody heard of this issue with 2002, or have any suggestions?
Thanks, Doug |
#2
|
|||
|
|||
Page Setup Problem
Doug:
You can't save changes to report page set up properties in an MDE database. You can only change them at run time from the report preview mode. In general you can't change any of those properties permanently in an MDE db, only in an mdb. -- Steve Arbaugh ACG Soft http://ourworld.compuserve.com/homepages/attac-cg "Doug" wrote in message ... I am running an MDE file on the Access 2002 runtime. I try to change the Paper Size on a report to A4, but it does not save the setting. I know this was an issue with Access 2000 addressed with KB 208912 and KB 240826. However, I am not changing the printer port as in 208912, and I don't have Name AutoCorrect enabled as in 240826. Has anybody heard of this issue with 2002, or have any suggestions? Thanks, Doug |
Thread Tools | |
Display Modes | |
|
|