If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access Query Invalid Argument Error with selected fields
An Access 2003 query that has been working fine, began throwing Error 3001,
Invalid Argument when it is run. It is a Make Table Query, and when 2 particular fields are included in the query, it gives this error. Without them, it runs fine. Both fields are "memo" type fields, but as I said, it has been working fine until this week or so. Any ideas? |
#2
|
|||
|
|||
P.S. I searched the Knowledge Base, it says that error occurs when the
Database is larger than 2 GB. My DB is ~290,000 KB, well below this limit. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What is the difference between 2002 and 2003? | Red Sonya | General Discussion | 2 | March 1st, 2005 05:10 AM |
Can't Open Data Source (Query) where criteria is defined by functi | l_stocky | Mailmerge | 7 | January 22nd, 2005 05:09 AM |
Here's a shocker | Mike Labosh | General Discussion | 2 | October 26th, 2004 05:04 PM |
Invalid Argument on saving query | brenda | New Users | 4 | October 4th, 2004 03:37 PM |
Access XP Compared to Access 2003 | Mardene Leahu | New Users | 1 | October 1st, 2004 05:11 AM |