|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 12th, 2004, 01:02 PM
|
|||
|
|||
Print a report to a non-default printer
Is there a way to do this ????
I have a report I want to send once an hour to a printer across the building. Obviously I don't want to make this printer the default because I print alot of other things too. Is there anyway to specify a printer (let's call it ADTPRINTER) for just one report ?? Thanks for reading 
|
|
#2
July 12th, 2004, 07:12 PM
|
|||
|
|||
|
Print a report to a non-default printer
Open the report in design mode, now from the file menu
select page setup, click the page tab and click the use specififc printer, Than identify the desred printer. Now this report will always print to the specified printer. Hope this helps. Fons -----Original Message----- Is there a way to do this ???? I have a report I want to send once an hour to a printer across the building. Obviously I don't want to make this printer the default because I print alot of other things too. Is there anyway to specify a printer (let's call it ADTPRINTER) for just one report ?? Thanks for reading .
|
|
#3
July 12th, 2004, 08:41 PM
|
|||
|
|||
|
Print a report to a non-default printer
Thanks Fons....that is exactly what I was looking for !!!
I really appreciate the help. "Fons Ponsioen" wrote: Open the report in design mode, now from the file menu select page setup, click the page tab and click the use specififc printer, Than identify the desred printer. Now this report will always print to the specified printer. Hope this helps. Fons -----Original Message----- Is there a way to do this ???? I have a report I want to send once an hour to a printer across the building. Obviously I don't want to make this printer the default because I print alot of other things too. Is there anyway to specify a printer (let's call it ADTPRINTER) for just one report ?? Thanks for reading .
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
| Printer disappears when default is set to a network printer | Tony | General Discussion | 1 | June 10th, 2004 12:20 PM |
| Report doesn't print unbound OLE Word object but does print data | Terry | Setting Up & Running Reports | 0 | June 8th, 2004 12:11 AM |
| Report uses specific printer. | George Wilson | Setting Up & Running Reports | 1 | June 7th, 2004 09:40 PM |
| Default Printer Problems | Ella | Setting Up & Running Reports | 1 | June 7th, 2004 12:01 AM |
Linear Mode
