If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Selected Table cells problem - range of cells is not continious
1. I had table of 3 columns and 4 rows.
2. Select cells row 1 column 3 row 2 columng 4 Word.Selection selection; bool isSelectionInTable = (bool)selection.get_Information( Word.WdInformation.wdWithInTable ); if( isSelectionInTable ) { int numberOfSelectedCells = selection.Cells.Count; // only 1 } Code returns only one selected cells Is there any way to get all 2 selected cells? Thank you, Igor |
#2
|
|||
|
|||
Selected Table cells problem - range of cells is not continious
No, that is not possible in VBA. See
http://support.microsoft.com/?kbid=288424. -- Regards, Jay Freedman Microsoft Word MVP FAQ: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. Igor Jecmenic wrote: 1. I had table of 3 columns and 4 rows. 2. Select cells row 1 column 3 row 2 columng 4 Word.Selection selection; bool isSelectionInTable = (bool)selection.get_Information( Word.WdInformation.wdWithInTable ); if( isSelectionInTable ) { int numberOfSelectedCells = selection.Cells.Count; // only 1 } Code returns only one selected cells Is there any way to get all 2 selected cells? Thank you, Igor |
Thread Tools | |
Display Modes | |
|
|