If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Separator problem on Cross Functional Flowchart
I inherited a cross-functional flowchart and need to make some changes to it.
I am trying to add a separator to the diagram, but it is not functioning properly. When I drag the separator over from the stencil, it doesn't extend all the way down the diagram. In fact, I can drag it anywhere on the diagran, not just in the band immediately below the title. When I try to copy and paste an existing separator, it pastes far above the flowchart, off the page. It does automatically extend to the bottom of the flowchart, but I cannot move it vertically so that it sits in its proper place (in the band below the title). I've posted screenshots of what I describe above at http://www.flickr.com/photos/13593099@N05/ Anyone have any ideas as to what's wrong and how I can fix it? This a pretty big and complex diagram, and I would hate to have to re-create it. Thanks. |
#2
|
|||
|
|||
Separator problem on Cross Functional Flowchart
On Tue, 2 Mar 2010 06:50:01 -0800, Buddy wrote:
I inherited a cross-functional flowchart and need to make some changes to it. I am trying to add a separator to the diagram, but it is not functioning properly. When I drag the separator over from the stencil, it doesn't extend all the way down the diagram. In fact, I can drag it anywhere on the diagran, not just in the band immediately below the title. When I try to copy and paste an existing separator, it pastes far above the flowchart, off the page. It does automatically extend to the bottom of the flowchart, but I cannot move it vertically so that it sits in its proper place (in the band below the title). I've posted screenshots of what I describe above at http://www.flickr.com/photos/13593099@N05/ Anyone have any ideas as to what's wrong and how I can fix it? This a pretty big and complex diagram, and I would hate to have to re-create it. Post a minimal version (just the functional bands frame) on the Visio Guy site. I'll compare it with a normal frame. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|