|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 12th, 2009, 04:49 PM
posted to microsoft.public.access.reports
|
|||
|
|||
Putting all record information in one column/field on report
I have a report set up pulling records from a query, everything looks great
except for 10 of the records (there are over 470 records in the report). Those 10 are right next to each other. The report puts all the information for the 6 fields in the last field area, pushing it all together. It then repeats these records normally, in the correct format. I have changed the properties of the report so that each field is set to grow/shrink, this did not fix anything. I don't know what is causing this, any suggestions would be great. -- Thorson 
|
|
#2
August 12th, 2009, 09:43 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
Putting all record information in one column/field on report
This sounds like some form of corruption. I would take a look at the record
source in datasheet view to confirm the records are correct. I they are correct, consider re-creating the report from scratch. -- Duane Hookom Microsoft Access MVP "Thorson" wrote: I have a report set up pulling records from a query, everything looks great except for 10 of the records (there are over 470 records in the report). Those 10 are right next to each other. The report puts all the information for the 6 fields in the last field area, pushing it all together. It then repeats these records normally, in the correct format. I have changed the properties of the report so that each field is set to grow/shrink, this did not fix anything. I don't know what is causing this, any suggestions would be great. -- Thorson
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
