![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hi,
I have selected data labels for my pie charts containing value and percentage. However, there are 0 values in the chart and I do not want to show them. I have tried 0%;;;; but it only hide those values in percentage while the value data labels are still visible. And when i use 0;;;; it hides the value data labels but the percentage labels are shown. Is there any way to hide both set of data labels if it is 0? thanks |
#2
|
|||
|
|||
![]()
I am not a great fan of pie charts so I have minimal experience with them,
but as an experiment I made a chart with this data A 3 B #N/A (formula =NA()) C 6 D 5 The B point did not appear on the chart So the advice seem to be the same for pie charts as fro all other: replace the zero (or empty cell) by =NA() best wishes -- Bernard Liengme Microsoft Excel MVP http://people.stfx.ca/bliengme "ck13" wrote in message ... Hi, I have selected data labels for my pie charts containing value and percentage. However, there are 0 values in the chart and I do not want to show them. I have tried 0%;;;; but it only hide those values in percentage while the value data labels are still visible. And when i use 0;;;; it hides the value data labels but the percentage labels are shown. Is there any way to hide both set of data labels if it is 0? thanks |
#3
|
|||
|
|||
![]()
Change your custom formatting to allow text to be shown
0;;;@ -- Best Regards, Luke M "ck13" wrote in message ... Hi, I have selected data labels for my pie charts containing value and percentage. However, there are 0 values in the chart and I do not want to show them. I have tried 0%;;;; but it only hide those values in percentage while the value data labels are still visible. And when i use 0;;;; it hides the value data labels but the percentage labels are shown. Is there any way to hide both set of data labels if it is 0? thanks |
Thread Tools | |
Display Modes | |
|
|