If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"Section width greater than page width" message
"Section width greater than page width" message
What causes this and what do I check? I'm modifying a report and have not changed any widths but I get this message everytime I run the report. |
#2
|
|||
|
|||
"Section width greater than page width" message
You must have some control whose right hand edge extends too far.
-- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no e-mails, please!) "David" wrote in message ... "Section width greater than page width" message What causes this and what do I check? I'm modifying a report and have not changed any widths but I get this message everytime I run the report. |
Thread Tools | |
Display Modes | |
|
|