If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
LAN Admin recovered DB, now I can't make design changes
Hi,
I had our LAN Admin recover a backup copy from the server and now I an unable to make any design changes to my DB. I am the only one currently using it. I am using A07 and the DB is not split & sits on our shared network drive. Any simple directions you could provide would be greatly appreciated!! |
#2
|
|||
|
|||
LAN Admin recovered DB, now I can't make design changes
You did not say if you could edit or add data. If not then the file
attributes may be set as read only. Go to that network drive and right click on the file to check the properties. -- Build a little, test a little. "crbqa" wrote: Hi, I had our LAN Admin recover a backup copy from the server and now I an unable to make any design changes to my DB. I am the only one currently using it. I am using A07 and the DB is not split & sits on our shared network drive. Any simple directions you could provide would be greatly appreciated!! |
Thread Tools | |
Display Modes | |
|
|