|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 14th, 2008, 11:46 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
Change the print are for a header
I am using woor 2007 and i have just creasted a new header. But as part of
the header I have used a thick line that goes from one side of the page to the other. This causes a problem as it is outside the print area. How can i change the print area in the header so this prints and not effect the rest of the layout of the document? 
|
|
#2
April 15th, 2008, 12:58 AM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Change the print are for a header
Hi Sean,
If you save the file as a PDF and print that, everything should be OK. The reason Word complains is that the printer driver tells it that it can't print that close to the edge. PDFs have no such limitations. Cheers -- macropod [MVP - Microsoft Word] ------------------------- "SeanO" wrote in message ... I am using woor 2007 and i have just creasted a new header. But as part of the header I have used a thick line that goes from one side of the page to the other. This causes a problem as it is outside the print area. How can i change the print area in the header so this prints and not effect the rest of the layout of the document?
|
|
#3
April 15th, 2008, 04:19 AM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Change the print are for a header
Thanks, works now
"macropod" wrote: Hi Sean, If you save the file as a PDF and print that, everything should be OK. The reason Word complains is that the printer driver tells it that it can't print that close to the edge. PDFs have no such limitations. Cheers -- macropod [MVP - Microsoft Word] ------------------------- "SeanO" wrote in message ... I am using woor 2007 and i have just creasted a new header. But as part of the header I have used a thick line that goes from one side of the page to the other. This causes a problem as it is outside the print area. How can i change the print area in the header so this prints and not effect the rest of the layout of the document?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
