If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can't edit header depth
I have a 300 page document with soft break sections.
At the fourth break, the header depth changes from two line spaces to four inches. All settings for page set-up and margins are exactly like the previous settings. Do I have a corrupted document or is there a way to fix this? -- RCCPIO |
#2
|
|||
|
|||
If the vertical alignment of the section is set to Top (Layout tab of Page
Setup), then display nonprinting characters (Ctrl+*) and make sure you don't have any extra, empty paragraphs. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA Word MVP FAQ site: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. "RCCPIO" wrote in message ... I have a 300 page document with soft break sections. At the fourth break, the header depth changes from two line spaces to four inches. All settings for page set-up and margins are exactly like the previous settings. Do I have a corrupted document or is there a way to fix this? -- RCCPIO |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Same header but even/odd footer (sorry for the new thread) | B?atrice Karjalainen | Page Layout | 1 | December 16th, 2004 01:40 AM |
Do not print Page header with a section header | Dhutcheson | Setting Up & Running Reports | 1 | October 15th, 2004 11:05 PM |
Need last page with different header | Kitty | General Discussion | 2 | September 15th, 2004 08:38 PM |
Headers and Footers | Pat Jennings | Page Layout | 9 | July 29th, 2004 07:39 PM |
Excel-Footer Mass change of only Header and not footer | M.Raguram | Worksheet Functions | 1 | January 16th, 2004 01:30 PM |