If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
finding a difference of list of numbers
I have a report that is a list of measurements that are taken from measuring
different areas of the body...ex...shoulder width, bicep, chest etc. I am wanting to list each measurement then at bottom of report show the difference...whether the measurement indicates loss or gain. how do i do this? Thanks! |
#2
|
|||
|
|||
finding a difference of list of numbers
By loss or gain, do you mean from the last time the measurements were taken?
Steve "LTOSH" wrote in message ... I have a report that is a list of measurements that are taken from measuring different areas of the body...ex...shoulder width, bicep, chest etc. I am wanting to list each measurement then at bottom of report show the difference...whether the measurement indicates loss or gain. how do i do this? Thanks! |
#3
|
|||
|
|||
finding a difference of list of numbers
say for example on 06/05 i measured your bicep at 14 inches...on 07/05 i
measured your bicep at 13.5...on 08/05 i measured your bicep at 14.5. i want to see a total that shows me the loss or gain each time a new measurement is documented...so to answer your question i guess it would be the last measurement compared to the original/base measurement. could there also be the ability to show the loss or gain between each month of measurements in a seperate column??...for example from 06/05 - 07/05 there was a loss of .5 however from 07/05-08/05 there was a gain of 1. "Steve" wrote: By loss or gain, do you mean from the last time the measurements were taken? Steve "LTOSH" wrote in message ... I have a report that is a list of measurements that are taken from measuring different areas of the body...ex...shoulder width, bicep, chest etc. I am wanting to list each measurement then at bottom of report show the difference...whether the measurement indicates loss or gain. how do i do this? Thanks! |
Thread Tools | |
Display Modes | |
|
|