|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 10th, 2004, 12:22 AM
|
|||
|
|||
Visio 2003 and NT4 problem
I open a Visio drawing with Visio 2003 from an NT4 mounted
share. When I save the drawing the file becomes corrupted. To further complicate the situation this does not appear to happen on other NT4 systems - and all our NT4 systems appear to be identical configurations. Any help/ideas would be appreciated. 
|
|
#2
August 10th, 2004, 02:42 PM
|
|||
|
|||
|
Visio 2003 and NT4 problem
Are you running it on a supported system?
Microsoft Windows 2000 with Service Pack 3 (SP3) or later, or Windows XP or later Al "Tony Veld" wrote in message ... I open a Visio drawing with Visio 2003 from an NT4 mounted share. When I save the drawing the file becomes corrupted. To further complicate the situation this does not appear to happen on other NT4 systems - and all our NT4 systems appear to be identical configurations. Any help/ideas would be appreciated.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
