If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Conversion from Access 97 to Access 2002
I converted an Access db from 97 to 2002. Mostly the conversion went
smoothly. However I'm having a problem with some reports. Opening one of the reports for viewing or even closing a report that is in design mode shuts down the database AND Access completely. I tried importing the reports directly from both the old version and from one copy of the converted file to another; in both cases Access shuts down completely. The queries underlying these reports seem to work ok when run by themselves. I'm not aware of any Active X controls on the reports. The references look to be set correctly. Any ideas? Thanks in advance, Dale Matt |
#2
|
|||
|
|||
Conversion from Access 97 to Access 2002
1) Open in design view, then save as something esle. See if that new saved
version opens. If not ... 2) Open a new blank report. Copy and paste the controls from the old into the new. Do the same with any VBA. Then see if that new version opens. Dale Matt wrote: I converted an Access db from 97 to 2002. Mostly the conversion went smoothly. However I'm having a problem with some reports. Opening one of the reports for viewing or even closing a report that is in design mode shuts down the database AND Access completely. I tried importing the reports directly from both the old version and from one copy of the converted file to another; in both cases Access shuts down completely. The queries underlying these reports seem to work ok when run by themselves. I'm not aware of any Active X controls on the reports. The references look to be set correctly. Any ideas? Thanks in advance, Dale Matt -- Message posted via http://www.accessmonster.com |
Thread Tools | |
Display Modes | |
|
|